README.TXT - Help file for stand-alone version of SRS IGC DataLogger

FILE LISTING
-------------------------------------------------------------------------------
setup.exe       Installer for SRS IGC Datalogger
visa201.exe     VISA Driver installer
Data.001        Application and LabVIEW Run Time Engine
readme.txt      This file
appendix_d.doc  Appendix to RGA manual describing use of the development kit

INSTRUCTIONS
-------------------------------------------------------------------------------
1) Run setup.exe

2) After the application and run time engine are installed, run visa201.exe

3) After installation of the VISA drivers, run SrsIgcDatalogger.exe

PLEASE NOTE:  On some operating systems, a pop-up message box may appear
BEHIND a box labeled "Please wait while the Windows Installer is configured".
You may need to click on this box in order to reveal the pop-up box labeled
"Your computer must be rebooted before this installation can continue.
Would you like to reboot your computer now?"  If you seem to be waiting for
a long time while your system's hard drive is not active, you should click
the box labeled "Please wait while the Windows Installer is configured" to
reveal the pop-up box, and make the appropriate choice to reboot immediately
or to post-pone the reboot after the install.

THE IGC LAB VIEW DRIVERS ARE NOT INCLUDED IN THIS STAND ALONE APPLICATION
DISTRIBUTION.  The development kit requires you to have installed LabVIEW 6i
(available from National Instruments, Incorporated) on your system.
The drivers are a free download from the SRS web site (www.thinksrs.com).
